Jeep Grand Cherokee Forum banner
1 - 14 of 14 Posts

Utah_ZJ

· Registered
Joined
·
1,849 Posts
Discussion starter · #1 ·
I have the yoke and front drive shaft from my old setup that I will likely never need, perfect for upgrading your setup to u-joints. Double cardan has less than 7k miles on it since being rebuilt. Get it all for $120 shipped.
 
Discussion starter · #12 ·
I need a shaft about 3" longer than stock, and I need U joint yokes to replace my CV yokes. Are you saying all of the shafts you have are the same?
No, I was saying that the ZJ and WJ both use the same yoke when doing the swap. Measure from the pinion nut to the collar on your front output shaft and get back to me.
 
1 - 14 of 14 Posts