Jeep Grand Cherokee Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
I got some nice 10x15 wheels with a -42mm offset.

Currently there are 32x11.50 tires mounted on them. My 5.9 is at stock height. Of course it's impossible to mount them and still be able to steer. What would be needed to be able to drive them whiteout clearance issues (I don't do off-roading and flexing).
I hate those pizza cutter tires, so I'm also thinking about 325/60 R15 as an alternative. They're close to 30" tires. Will they be a direct fit at stock height/2" BB? Will the width cause problems?

Thank you!
 

·
Registered
Joined
·
35 Posts
To run those wheels with 32's you're probably going to need at least 4" lift, or some cut-out fender flares and a couple inches of lift. I have 15X10's on my 5.9 with 33's and almost 7" lift and the tires rub BAD when turning while driving on the street (not to mention the rubbing off-road). I am going back to my 15X8's because they did not rub.
 

·
Registered
Joined
·
3 Posts
I have 33X12.5X15 on my 98 5.9 Limited.They were on it when I bought it.It has a 3-4 inch lift.However no clearance or rubbing issues whatsoever.
Cheers
Mike
 
1 - 4 of 4 Posts
Top