Jeep Grand Cherokee Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hi,
I'm planning to swap my stock Dana 30 with a XJ hp Dana 30 with WJ knuckles. Anyone could tell me if it is possible to keep the WJ wheel bearings in order to avoid adding the JKS 0,25" spacers? If that was possible, I wouldn't have to redrill the WJ discs. I would use the wheel spacers to adapt the different stud patterns.

Regards
 

·
Registered
Joined
·
3 Posts
hp 30 wj knuckles

i have bought the same set-up and was wondering if ANYBODY has done the same conversion on a 93 ZJ .....any advise good or bad will be appreciated
 
1 - 2 of 2 Posts
Top