REALLY helps to have a second person helping out the way I do it, but it can be done by one person if you put a jackstand under the door. When you open up the door, you should notice that there are 4 bolts holding the door to the Jeep. These should be 10mm. Take those out while your buddy holds the door. Now you have the electrical harness. There's a tiny torx screw in there that you have to unscrew and then you can pull the harness out. That part is kind of a PITA. Now your dome lights are going to be on all the time. Get a small flat head screwdriver and pop out the door switch pins. Pull the wiring out a little bit and there's a harness you can unplug. The Jeep now thinks the doors are shut and your dome lights go off.
I took my doors off and put them back already with no problem. Now I have them off again and as trying to put them back on but the door hits the front quarter panel and bends it when you open and close it on both sides. is there a shim that I'm missing in there or how do I just it so it doesn't do that?
101 - 103 of 103 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to Jeep Grand Cherokee owners and enthusiasts. Come join the North American Grand Cherokee Association and participate in discussions about performance, modifications, classifieds, off roading, trail reports, troubleshooting, maintenance, and more!