[Crasher]

I am about done (for now) with my ZJ. I have to build the rear bumpstops inside the coils yet and come up with a rear sway bar that will work with the Clayton triangulated rear arms. I can't find where I saw the anti-rock kit installed on a ZJ and if it was with Claytons. I've seen the wrangler bar adapted to one, but want something better. Where do I look?

 

[Crasher]

I looked at doing it that way, but when it is crossed up, the lower arm appears to be outside of the unibody rail. I would have to offset it and reenforce as well. I have the high clearance lower control arm brackets and axle is pushed back further. I welded a 1 1/2" pipe coupler to the upper coil perch to keep the coil lined up when extended. My limiting chains allow the coil to drop down a couple of inches. When it compresses, it bows in very little, so screwing a short nipple with a bumpstop on the bottom end into the 1 1/2" coupler will be pretty simple. It will work just like the front. If I have problems, I was going to do it your way.