Well i am thinking about building some long arms for my 96 zj over the winter. I am planning on making a crossmember similar to what claytons sells and running a 3 link front. I am looking in to using a flex joint and a rubber bushing on the lower arms. Would i be better off putting the rubber bushing on the frame end of the lower arm or should i put it on the axle end?
Also, just wondering if it is possible if you could run a radius arm setup in the rear? To me it looks like it would work out fine. It is still keeping the pinion in the same spot just like it would work on the front. Does anybody see any problems with building the rear like this?
Thanks,
Ben
Also, just wondering if it is possible if you could run a radius arm setup in the rear? To me it looks like it would work out fine. It is still keeping the pinion in the same spot just like it would work on the front. Does anybody see any problems with building the rear like this?
Thanks,
Ben