Jeep Grand Cherokee Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello everyone,
Just bought a 2019 WK2 Limited in Red Velvet. It is going to be a daily driver for work (as a REALTOR.) Looking to do some minor customization; de-badge it for a cleaner look, tint front windows to match the rear, get a set of winter wheels/tires, under chassis lighting and adding a trailer hitch.

Question: I am thinking about a 2" suspension lift. Can I do it without having to address a litany of engineering issues (drive shaft geometry, speedometer etc) because this would be my first time. Recommendations???

Thanks for your time.
 

·
Registered
Joined
·
24 Posts
First, on the lift, will you be using this vehicle to show properties post covid19 you don't want prospects struggling to get into your vehicle.
Second check state and local laws regarding front window tint. Even in legal states excessive tint a cop magnet.
Speedo re-calibration is only necessary for larger diameter tires. Don't know about independent suspension mods but on solid axle Jeeps two inches is withing drive shaft angle tolerance as lns as no excessive mileage on U-Joints. Lifted a high mileage Plymouth Trailduster once ended up replacing every u-Joint over the next 4 months bc flexed past wear point.
 
1 - 3 of 3 Posts
Top