Jeep Grand Cherokee Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
726 Posts
Discussion Starter #1
the plastic fascia tore off my jeep and im looking to have a bumper made.

has anyone had one custom made that was considerably cheaper than the arb?

i cannot go back to the plastic even if i have to drive without it for awhile.

thanks
mike

if someone can please send me the install directions for the arb on a zj that would be cool. id like to see how it mouts up to the frame.
thanks
[email protected]

thanks guys, by the way, buy my bfgs in the for sale page.


<font size=-1>[ This Message was edited by: Bender on 2002-02-25 17:13 ]</font>
 

·
Registered
Joined
·
672 Posts
i like my arb. i also tired of putting the worthless piece of plastic on so i just drove around w/o one until my arb came in. it is a good idea to go ahead and paint the cross support and other parts up front b/c there are a few small spots that will show after an arb is install. tomken and trailready also make zj bumpers.

ps: i have already put a dent in my arb. :O)
 

·
Registered
Joined
·
227 Posts
ARB install is incredibly simple. Pull the plastic off (already done that apparently), drill a couple holes in front bumper/beam, part of a bracket goes behind that, another part goes in front of, a few bolts go through to sort of clamp them around the bumper/beam and frame rail, ARB sits on top of these brackets and has adjustments up/down for proper fit. All this is in the instructions and as I remember doing mine.
 
1 - 3 of 3 Posts
Top