[jhedman2]

Rather than pay the $200 for a dealer to put in new engine mounts, I am getting ready to put them in myself. Anyone out there have any tips for me. I am sure it's not difficult but tips are always beneficial. www.jeeplife.info

 

[ViNcE-ZJ]

Did mine on my 5.2, there is not very much room for your hands, so an air-ratchet would be very beneficial. Other than that its pretty straight foreward...mine were baaad pretty much crumbled! :lol:

 

[Justin]

motor mounts

I've got the 5.2 and recently did the mounts. Some tips:

1. Don't plan on being anywhere for a few hours if this is the first time
2. Turn the radio on, it helps lower stress
3. Beer

Seriously though, some PB Blaster or similar on the bolts a few days in advance may help. Just make sure the engine's jacked up or the bolts won't come out. I used a block or wood between the jack and oil pan. Good luck, take your time and try not to get too pissed.

 

[Jeepin' Wolf]

LOL, parking lot in Moab comes to mind.... :lol:

 

[jhedman2]

Thanks for the advice, I just got the new ones in today. Ordered mine from Tellico, they are half the price of the originals and actually look a little bit better in quality. Thanks again. P.S. got plenty of the beer waiting and lots of things to throw. :lol:

 

[jhedman2]

Thanks again everyone, put em' in today. No wonder the dealerships want so much to do it. That was a pain, caused my tendonidis to kick back in. Before I buy any more parts for my Jeep, I am going to buy an air compressor and an air ratchet. That would have made things so much easier. www.jeeplife.info.