Jeep Grand Cherokee Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
95 ZJ 5.2l. I’m fighting a loose wire/bad connection on the wires feeding the bottom of the coil.

1. Any idea where to start looking? I can usually wiggle the wire loom and it will start and run.

2. Can I run directly from the battery to the bottom of the coil? According to FSM, wires come from PCM #19 ignition coil driver and Automatic Shut Down Relay. Both through splices and a couple different connectors.

Thanks for any assistance
 

·
Registered
Joined
·
29 Posts
If you are wiggling the loom down by the coil I would disconnect the coil connector and fish the cable up behind the belt tensioner and inspect it. I looked at mine and it goes a little close to the exhaust manifold and your harness may be burned. Den
 
1 - 2 of 2 Posts
Top