Jeep Grand Cherokee Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
102 Posts
Discussion Starter #1
I'm at 6" front and rear. I have the front adj. UCA's & LCA's and they go on tomorrow. Does anyone have the lengths that are good fot this amount of lift.Or, how do you determine the proper length for the arms. In some archives, I read that the axle needs to be centered in the wheel well while at full compression??? If anyone has some measurement, that would be great, atleast a good place to start.
Thanks All,
Sam

<font size=-1>[ This Message was edited by: Colt45auto on 2002-02-13 07:01 ]</font>
 
E

·
Guest
Joined
·
0 Posts
It should be centered as much as allowed by:

-driveshaft length
-pinion angle
-rubbing at limits
(and probably in that order)

Simpler to do before the springs go in. :D

-Dave
 
1 - 3 of 3 Posts
Top