Jeep Grand Cherokee Forum banner

Looking for a hand

4K views 2 replies 2 participants last post by  RIGHTAWAY 
#1 ·
I would like to swap a 242 in place of my 249 but i dont have the tools or the knowledge to swap over the front parts of the tc. I will bring you both tc and you can help me swap them over. I'm located in the lehigh valley
 
#2 ·
What year is your rig? You can bolt a 242 directly to it as long as you get one within the correct year range. Takes 14mm (or 9/16) to separate the case from the trans and whatever the crossmember bolts are, I forgot what they were. Too me around an hour and a half, and that's including replacing the u-joint in my rear shaft.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top