|
: where does everyone run the wires through the fire wall violatedppl 01-31-2006, 08:04 PM I have had trouble trying to find a spot to run wires for my aux lights and PA speaker I am trying to put in. I have yet to find an some what open spot to run the wires through, And I was wondering what everyone else has done to kinda give me an idea where would be a good spot to run mine. Pics would be a plus, thanks wildabeast4 01-31-2006, 09:36 PM actually i had that same question...but i have heard of simply drilling a new hole in the firewall???? wildstylejesse 01-31-2006, 11:46 PM driver's side floor board. It's near the center console. When looking into the engine, there should be a rubber plug to the left of the window washer fluid and to the right of the air intake. It's there and is easy to get to. wildstylejesse 02-01-2006, 12:15 AM Here's from the engine...it's near the transmission dip stick http://i9.photobucket.com/albums/a74/wildstylejesse/IMG_1965.jpg Here's from the driver side floor board area...use the gas as a reference. http://i9.photobucket.com/albums/a74/wildstylejesse/IMG_1963.jpg bchcky 02-01-2006, 06:40 AM actually i had that same question...but i have heard of simply drilling a new hole in the firewall???? thats quite common. just make sure you know what is on the other side when you drill. and make sure you seal it up well once you run the wire through to the other side. staticprevails4 02-01-2006, 10:11 AM When I ran my fogs I ran the wire through the fire wall where the fuse panel wire came through violatedppl 02-01-2006, 10:22 AM thanks for the info, When I was looking I never saw the spot up by the gas pedal. now just to run the wires dusty122 02-01-2006, 10:57 AM on my 93 i was able to pull off the plate where the clutch would go through if you had a manual tranny. Im running 0 GA and a few other things through it so i needed some sereus space. Idk if that plate exists on nwere models because i know they dropped the manual tranny option shortly after my 93 Luken8r 02-03-2006, 09:20 AM I punched a hole through the firewall right by the throttle cable. It was the only relatively flat section that I could get my drill to. I only have one 12gua wire going through, so the hole isnt too big. I plugged it up with some RTV and its now watertight as well. NRV95ZJ 02-04-2006, 09:02 AM yea, drilling isn't the bet idea. i learned this the hard way. 2 minutes later after drilling through my transmission control module and only being able to use 2nd and 4th gear i learned the hard way..... zacharykro 03-09-2007, 05:19 AM i punched throught mine. it was pretty easy id say. i had to run a bunch of lights and the power cord for my amplifier. 6Banger 03-09-2007, 11:14 AM unscrew the two top coolant tank screws. tip it foward a little. tape your wires to a long screw driver. and poke them through the grommet that i there. go to the inside of you rig. remove glove box and side panel of dash on passanger side. look for tip of screw driver and cut the tape. and your through with no drilling. it will take alittle time to get it through the grommet. good luck ill search for pics | |