Ok folk, I want to put 32 11.5 15 SSrs on my rig, but need to know exactly what kinda mods I would need to accomplish.


95 4.0
3 TF 3EZ

first i would do a search ;)

then i would get a lift or a sawsall :thumbsup:

nathan

Thank you for your inspiring answer. A teraflex 3 is already installed. If you are trying to be a smartass well haha :spank: . I know I can put 31 10.5 will this lift with min. rub. Searching just says that there would have to be some minor trimming. Is 32 11.5 ssrs aceptable for this lift or not?

I honestly couldn't tell you definatly but I believe those tires run a little on the big side so maybe a small BB would help
________
HIGH & LOW BLOOD PRESSURE FORUMS (http://www.health-forums.org/high-low-blood-pressure/)

IMHO..... either stay at current height and trim. Or - Add a 1.5" - 2" BB.

I would say go with the 1.5" BB, its the cheapest way to go and the only trimming, if any, will be where you rubb when your wheels are at full turn, the bottom of the front bumper. Good luck, and I would contact Anthony over on the 'other' board. peace

I ran the tera s3z for my first lift. Bought some 32" ssr's and did some major siping on the way home from when i bought them. Needed the bb on top to clear them and had to do some slight trimming. New ssrs are closer to a 33 inch tire.

I wouldn't do any Swamper series 32" tire w/o 4.5" of lift. You can check out the pics I have at my site to see my rig at 6"+ of lift with 32" SX's.